How to edit gcode? - Is it possible to salvage a job by restarting after a jammed extruder? - Snapmaker 2.0 - Snapmaker: where creation happens

Stepped away for a bit, glad you’re making some progress! Yea, the G92 command is a way to set an arbitrary reference point for future commands. It sounds like you got it, but I’ll just reiterate: that G92 E0->G92 E115.7035 change was because over, say, 1000 lines of gcode 115mm of filament was extruded, and if I don’t change the reference as soon as the first G1 X Y E116 is executed it’ll extrude 116mm of filament. So you have to tell the machine that it’s starting at 115.7 so it extrudes 0.3

Dual Extruder Problems & Gripes Mega Thread - Snapmaker 2.0

ANYCUBIC Mega Pro 3D Printer 3D Printing & Laser Engraving

How to edit gcode? - Is it possible to salvage a job by restarting

Insert pause or custom G-code at layer

Bed Leveling/Adhesion Issues for the Dual Extruder - Snapmaker 2.0

Troubleshooting flowchart for clogging/filament not extruding (J1

Dual Extruder problems? - Snapmaker 2.0 - Snapmaker: where

Dual extruder calibration example - Snapmaker 2.0 - Snapmaker

Bed Leveling/Adhesion Issues for the Dual Extruder - Snapmaker 2.0

J1 Community FAQs - Snapmaker J1 - Snapmaker: where creation happens

Issues with generating g-code? - Getting Started - Snapmaker

Robox 3D Printer, Dual Extruder, High Definition