Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

I’m trying to understand how to tune overhangs for my Polymaker ASA filament. I had dialed the fan speed way down to promote layer adhesion, except for overhangs. But overhangs came out shitty: I had: 0% fan @ 35s 20% fan @ 5s 100% fan for overhangs I then adopted the bambu ASA fan settings (leaving everything else the same): 25% @ 35s 90% @ 3s 80% for overhangs The result is much better: Notice that the bad model has 100% fan for overhangs and the good one only 80%. So is less fan

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

Blobs on overhangs - Troubleshooting - Bambu Lab Community Forum

How to show Overhangs in Bambu Studio @BambuLab #bambustudio #3dprinting #3dslicer

Slow Down for Overhangs

Bambu Lab X1 Carbon Review: Living In The Future

Error after upgrading to Bambu Studio v1.7.7.88 : r/BambuLab

Bambu Studio: How & WHY to use Support Overhang Shading. Also Orca! Bambu Lab P1P - P1S - X1C

Bambu Lab P1P 3D printer tested extremely fast and precise

Bambu Studio: How & WHY to use Support Overhang Shading. Also Orca! Bambu Lab P1P - P1S - X1C

Bambu Studio: How & WHY to use Support Overhang Shading. Also Orca! Bambu Lab P1P - P1S - X1C

How to do support structures for small round overhangs in Bambu Studio : r/BambuLab