Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

Hey Guys, So I had to put in new thermistor recently, did some other structural changes (60mm height increase) and wired in a fan which isn’t currently connected. Yet now I am getting this issue with my hotend where once the print start the temperature drops even though it looks like the extruder is still rocking it. I ran PID autotune, stored the values, brought the bed and then the hotend up too 230C using Repetier. Then I dropped in the GCODE. You can see down below the temperature curve. T

Make 3d printing 2014 by wattronix - Issuu

Critical review of FDM 3D printing of PLA biocomposites filled with biomass resources, characterization, biodegradability, upcycling and opportunities for biorefineries - ScienceDirect

3D Printing Troubleshooting Guide

Can't wait explore the world of 3D printing with my Christmas gift! Is there anything I should know that not a lot of people talk about? : r/3Dprinting

Review of the Pirx 3D Printer

High-performance polymer 3D printing – Open-source liquid cooled scalable printer design - ScienceDirect

I've got like an hour and a bit left of my print. Why did this happen? : r/FixMyPrint

Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

3D Printing Troubleshooting Guide

LulzBot Mini 2 Review

Extruder Struggling - AO-101 & AO-100 - LulzBot

LulzBot Mini Review: Compact, Powerful Yet Easy to Use

Mosaic Palette Users, Hello All, I recently changed out my ender 5 for a cr-10 v2 and I have been trying to get my palette working with it correctly