How to get inverse fill to follow outline without waste - Getting Started With LightBurn - LightBurn Software Forum

I have an fill layer I am trying to reverse I know i can put a box around it and get this Which does put most of the fill where i want it but it does not follow the cut outs of the original edges and it also has a ton of fill that is just a complete waste of time. Is there a way to get the fill i want to follow the edges with the tabs and not have so much fill where its not needed. Here is the file UR_Box.lbrn2 (597.5 KB)

Project, MultiBot CNC v2

How to invert engraving?! - LightBurn Software Questions - LightBurn Software Forum

Fill instead of clear area - LightBurn Software Questions - LightBurn Software Forum

Still struggling with layers - LightBurn Software Questions - LightBurn Software Forum

How to optimize contour filling? - Getting Started With LightBurn - LightBurn Software Forum

Outline lettering over fill - LightBurn Software Questions - LightBurn Software Forum

Filling outside the lines - LightBurn Software Questions - LightBurn Software Forum

Fill & Line is NOT gone from Lightburn Laser Software!

Filling outside the lines - LightBurn Software Questions - LightBurn Software Forum

Outline works fine but fill doesn't turn off from one side to the other or top to bottom - Marlin - LightBurn Software Forum

How to get inverse fill to follow outline without waste - Getting Started With LightBurn - LightBurn Software Forum